How do you install screens on your 2019 dynavap M? I can never get it in the grooves so i just settle for pushing it to the bottom of the tip. Know of any good techniques or recommendations?
If you have two condensers you can pin the CCD between the two and guide it in.
Push one in from the 'base' of the tip until it protrudes out of the top of the chamber.
Lay the CCD on it.
Place the other condenser on the other side of the CCD so the two condensers are holding it.
Then just press the CCD in slowly using the inner condenser as a backstop.
This should do me wonders thanks a Ton